Dial-UpConfiguration

 Step 1
In order to have dial-up access to the UNET computers, you must configure your modem properly.

NOTE: If you do not have a modem configured to your computer, Windows 2000 will walk you through the modem setup automatically. Once you have completed the setup, however, repeat this section to double-check the settings.

    

Choose the Start button at the lower left-hand corner of the desktop.
Scroll to Settings then to Control Panel.



 Step 2
Double Click Phone and Modem Options



If you do not have any modems configured to your computer, Windows 2000 will take you through the configuration step-by-step. Simply follow the prompts on the screen.

If you already have a modem configured in the Modems Properties window, highlight it and then click Properties.





 Step 3
Under the General Tab your Maximum Port Speed should be set to the speed of your modem.
f you do not know the speed of your modem, consult your owner's manual OR go ahead and
set the speed to 57600.

Click OK.

 


 Step 4
In order to dial in to the UNET network, you must configure the network components on your computer.
If you haven't already, you must Configure Your Modem

    

Choose the Start button at the lower left hand corner of the desktop. Scroll to Settings then to Control Panel.


 Step 5

          


Double-Click Network and Dial-Up Connections.



Double-Click Make New Connection


 Step 6



Windows should automatically start the Network Connection Wizard. Click Next to continue.



Choose Dial-up to private network. Click Next to continue.





Make sure dialing rules is deselected. In Phone number type the number you will dial
when connecting to UNET.

Click Next to continue.




Under Create this connection choose the option Only for myself. Click Next to continue.



The name you want to use for the connection is UNET. Enable the option
Add a shortcut to my desktop.
Click Finish to end the Network Connection Wizard.

You have completed configuring your computer for Dial-up Networking.
Close the Dial-Up Networking window.


 Step 7





Click the Start button at the bottom left-hand corner of the desktop and scroll to Shut Down...


 Connecting to UNET

Connecting
Double click on the UNET icon on your desktop.

In the Connect To window enter your network Username and Password.
Click Connect.

NOTE: This part will depend on the phone line you are using.   If you are using a direct line, use 8350501, otherwise, just type 9,8350501.  If you encountered busy tones or some connection problems, you can use 8860501.

You should see the connection process (as pictured below).

  
   
  


The Connection window will verify your information.

   
   
    

When the connection is complete, the window will say Connected to UNET

    

Minimize this window by clicking at its top right corner.
You should now be able to run your computer's Internet programs (Eudora, Netscape, etc.)

 

 Disconnecting

Close all of your network and Internet applications.
On the Taskbar at the bottom of the desktop, click on the Connected to UNET icon.

    

Click Disconnect.